How To Replace The LDS Motor On Your Roborock Robot Vacuum

If y'all've had your Roborock for a while, and then you may experience the laser and motor not working quite like it should. Peculiarly if accept pets, equally that clay and dust (and other things) can get into the module on top of the robot vacuum and cause it to non clean properly. Potentially running into furniture, walls, etc.

Luckily, in that location is a manner to fix this issue. It mostly has to exercise with the LDS motor on your Roborock robot vacuum. And beneath, we'll show you how to replace it. This is the easiest route to go, equally replacing the entire light amplification by stimulated emission of radiation module can be quite cumbersome and expensive. We'd only recommend doing this if your vacuum is outside of the warranty phase. Otherwise, you tin just send it into Roborock to get it fixed.

How To Replace The LDS Motor On Your Roborock Robot Vacuum

It may seem daunting to supplant the LDS motor on your Roborock robot vacuum, but it'south actually pretty simple. Here's what yous need to do.

Get-go, remove the dustbin and the cleaning tool from the robot vacuum.

Next, you're going to need to remove the cover that goes over the power button, dock and spot cleaning buttons. You will demand to use a bit of force to practise this, simply it will just snap correct off.

replace lds motor roborock — Remove upper housing trimming

Now, yous'll run across that in that location are half dozen screws holding the rest of the top cover (that covers the grit bin) in place. You'll demand to unscrew those. Then remove the acme cover assembly.

Next, yous will need to remove the LDS protective cover. There are five screws around it, hidden nether caps. Which are simple to take off.

Screen Shot 2021 02 15 at 2 33 16 PM — Remove LDS Protective Cover

With the LDS protective embrace removed, in that location are four more than screws around the motor that yous demand to unscrew.

Screen Shot 2021 02 15 at 2 33 54 PM — Remove LDS

In that location are two more than smaller screws that need to be removed, to remove the LDS Motor. Unscrew those.

Screen Shot 2021 02 15 at 2 34 22 PM — Remove LDS Motor

Then detach it from the balance of the module. And the motor will popular right out.

Now to put information technology back together, merely redo everything we just mentioned. Starting with reattaching the LDS Motor to the module with those ii screws. Then replace the 4 screws that puts the module back onto the robot vacuum.

Subsequently, y'all'll need to use the v screws for the LDS protective cover and put that back in identify.

Then you'll exist ready to utilise the six screws used for keeping the top embrace associates in place.

Pop the meridian cover back on, and put the dustbin and cleaning tool back inside, and you're all ready.

And that's it. It might seem daunting, merely it is actually pretty easy to do.